DC插座 直流DC插口 配合插头应为直径4.75mm，直径为1.7mm的针孔。 DC Power Socket

• 型号TDC-026 series
• 品牌瑞丰开关Switch Jack SerieS

详细描述

Specification

1. Rating : 2.5A/16V DC Max
2. Contact resistance : Contact resistance shall be less than 50 Milliohms at initial and 100 Milliohms after life test between a terminal of the socket and that of the mating plug; less than 30 Milliohms at initial and 60 Milliohms after life test between terminal of the socket in a closed circuited, when measured at a current of less than 100 Milliampere 1 KHz. The Mating plug use shall be
   cleaned and free from oxidation film of the surface.
3. Insulation resistance : Insulation resistance between insulated metal parts shall be 100 Megohm or more at initial and 50 Megohm or more after cold test, hot test, and humidity test when measured with a 500 volts D. C. insulation resistance meter.
4. Insertion and Withdrawal Force
   The insertion and withdrawal force shall be 0.3 – 3Kgs at initial and 0.2 – 2Kgs after life test
   with the gauge plug.
5. Terminal Strength
   The terminal shall be capable of withstanding a force of 500 Gram applied in any directions for
   10 second without loosing and breakdown.
6. life test : 10,000 cycles

 

Features

The mating plug shall be in 4.75mm diameter with 1.7mm diameter pin hole.

 

Material

Shunt Terminal : Brass, Tin plated
Tip Terminal : Copper Alloy, in plated
Ground Terminal : Brass, Tin plated
Plastic Housing : PA66

规范

 

额定值：2.5A / 16V DC最大

接触电阻：在插座的端子和配合插头的端子之间，接触电阻在初始时小于50毫欧，在寿命测试后小于100毫欧;当在小于100毫安1KHz的电流下测量时，在闭合电路中的插座的端子之间，在初始时小于30毫欧姆和在寿命测试之后为60毫欧姆。配接插头应使用

清洁并且没有表面的氧化膜。

绝缘电阻：绝缘金属部件之间的绝缘电阻在初始时应为100兆欧以上，而在用500伏直流绝缘电阻表测量时的冷试验，热试验和湿度试验后，绝缘电阻应为50兆欧以上。

插入和拔出力

插拔力在初始时为0.3〜3Kgs，寿命试验后为0.2〜2Kgs

与量规插头。

终端强度

该终端须能承受在任何方向施加的500克力

10秒，没有松动和故障。

寿命试验：10,000次循环

 

特征

 

配合插头应为直径4.75mm，直径为1.7mm的针孔。

 

材料

 

分流端子：黄铜，镀锡

尖端端子：铜合金，镀

接地端子：黄铜，镀锡

塑料外壳：PA66